Method of Increaing Raymond Mill's Yield

Zhengzhou Hongxing Raymond Mill is a stainless steel, jacketed, vertical grinding mill with an approximate max working capacity of 7000 kg. The fineness of the finished product can be adjusted from 0.044 mm to 0.165 mm according to requirements. All the finished particles have a good uniformity of fineness, with passing screen rate as high as 98%.

We supply Raymond mills for the chemical processing, mining and minerals processing, construction processing, metallurgy processing and numerous other processing industries. It is used for size reduction, dispersion, or specialized needs.

Zhengzhou Hongxing Raymond Mill can form an independent production system from the lump materials, crushing to finished powder and packaging. Its lighter unit weight than the conventional type guarantees easy handling and operation. And labor cost reduction is achieved by automating many of conventional manual operation.

Raymond mill is common industrial powder equipment, and the main factors of affecting Raymond mill's yield have been listed here:

1. The hardness of the material. It is obviously that the harder of the material and the harder for milling of Raymond mill and the worse for Raymond mill. Also, if the Raymond mill gets slow milling speed, its milling ability will drop down.

2. The humidity of materials. When the Raymond mill's material is too wet for milling, the material is easily adhere to inner of Raymond mill and also easily conveying the course of the next block, resulting in reduced ability of Raymond powder mill.

3. The fineness of the output material. The finer material you want, the little ability of Raymond mill present.

4. The composition of material. Fine milling material contained before milling is bad for Raymond mill. Because these fine powder have adhesion effects that easily block conveying. So we should process before starting of Raymond mill.

5. Material viscosity.

6. Raymond mill main part's wear resistance. In our common sense, the ability of Raymond mill is up to the wear parts.